手感漆油墨
品牌：MY INK 名稱：手感漆油墨 編號：5415616
概述：手感漆專用油墨是采用高質改性樹脂和高級顏料經過細制研磨加工組合而成，具有遮蓋力強、附著力佳、流平性好等特點。
適用范圍：手感漆專用油墨各種噴過手感漆、橡膠漆、彈性漆的工件表面絲印、移印。
印刷：
選用網目為250-350目的網板。
1．用配套專用稀釋劑開油
2．用718洗網水洗網。
3．添加10%的配套硬化劑增加附著力,提高產品的通用性和墨層硬度。
干燥時間：
表干時間自然揮發5-10分鐘，實干時間在添加10%硬化劑，必需烘烤干燥65℃烘烤60分鐘；80℃烘烤30分鐘；后達最佳性能；
測試（完全干燥后）：
1．3M膠紙粘在畫有百格的油墨表面45度角迅速拉起沒異狀。
2．500克力橡皮耐磨60次，耐酒精50次以上。
測試方法（完全干燥后）：
1、3m膠紙粘在畫有百格的油墨表面，45度角迅速拉起不脫油;
2、純度99%的工業酒精，一千克砝碼用棉布包住在油墨表面，以水平力來回拉200次無脫色;
3、 耐磨：橡皮擦500g力水平來回擦300次。
使用方法：
1．建議用我公司專用稀釋劑進行稀釋，不建議使用783慢干稀釋劑稀釋，使用前應充分?jǐn)嚢?，用后隨時密封。
2．攪拌時加本公司配套開油水10-12%，稀釋到印刷適合粘度，移印稀釋使用移印專用稀釋劑；用718洗網水清洗。
3．不得與其它類型油墨混合使用，否則容易出現其他附著力，化學反應等不良現象。
4. 加入固化劑的油墨使用時限為8小時，過期請棄用，剩余油墨不可回收
注意事項：
1．各種承印物料的外觀相似，但可能會是不同的材料，客戶需先試印，確其符合要求后，再批量生產。
2．在移印過程中，如出現拉絲或散開，可適當加入一些慢干膏即可;
3．環境溫度過高，將會影響油墨原有質量。白色超越150都會變色，烘烤時請用木質材料墊底進行烘烤，不得直接接觸鐵
4．根據氣候變化，請遠離火源，陰暗處15度-30度環境下存放
Brand: but MY name: feel paint inks Numbers: 65496
Feel paint inks
Summary:
Feel special ink is USES the high-grade paint modified resin and senior pigment after fine grinding process of a combination of strong power, has covered, adhesion, good flow ping sex is good wait for a characteristic.
Suitable for: feel special ink spray paint of paint, feel a paint and elastic rubber paint surface of workpiece printing, pad printing.
Printing:
Choose for 250 350 mesh screen purpose.
1. With matching special thinner, open oil
2.
3. Add 10% of form a complete set, improve product increase adhesion stiffening agent the versatility and ink layer hardness.
Drying time:
Dry time table natural volatilize 5-10 minutes, action in time added 10%, must bake stiffening agent 65 ℃ dry baking 60 minutes; 80 ℃ bake 30 minutes; To best performance after;
Test (dry) :
1.3 M tape stuck in the picture has's ink surface 45 degree Angle quickly pull up no different shape.
2.500 g force rubber wear-resisting 60 times more than 50 times, resistance to alcohol.
Test method (dry) :
1, 3 m stuck in the picture has the tape's ink surface, the 45 o Angle quickly pull up not to take off the oil;
2 and purity, 99% of industrial alcohol, a kilogram of Jordan farmar cover with cotton cloth in ink surface to pull back and forth horizontal force 200 times without decoloring;
3, wear-resisting: the eraser 500 g force level wipe 300 times back and forth.
Method of use:
1. The proposal with my company special thinner to dilute, not recommended dry thinners diluted 783 slow, before the use should be fully mixing, use at any time after sealing.
2. Add the company supporting stirring open 10 to 12%, oil and water dilute the printing for viscosity, pad printing dilution use moving printing special thinner,; Use clean water to wash the nets 718.
3. Not with other kinds of printing ink mixed use, otherwise easy to have other adhesion, chemical reactions and other bad phenomenon.
4. Add hardener inks use time limit for 8 hours, please not used, the remaining expired ink not recycling
Note:
1. All kinds of printing material appearance similar, but may be of different material, customers are required to meet the requirements of the ShiYin, indeed, its, then batch production.
2. In moving printing process, such as a wire drawing or away, can be appropriately to add some slow dry paste can;
3. Environmental temperature is too high, will influence the quality of the original ink. White will change color, roasted beyond 150 when please use woodiness material bottom, and may not directly contact roast iron
4. According to climate change, please away from fire, the shadows 15 degrees-30 degrees environment for
