人體感應開關說明書

產品簡介：

基于紅外技術的自動控制，靈敏度高，可靠性高，智能化，人性化，

本開關單極性設計，可直接替換遙控開關，手動開關，聲控開關，

摸開關。無需改動原有布線，使用方便，可接各類燈具，排風扇等負

載。

適用范圍：

本開關能負載白熾燈(燈泡)和節能燈LED燈環形燈管，日光燈等燈源，廣泛適用于:賓館、旅館、辦公室、工廠倉庫、住宅小區等處的車庫、樓道、走道、出入口、衛生間、電梯間等公共場所,配套燈具使用。是照明開關的最佳選擇。

功能特點：

1. 全自動感應

人來燈亮，延時一定時間后，人離燈熄。節能環保。

2. 自動測光

3. 應用光敏控制,白天或強光下不感應,夜間或弱光下可感應.（也可做全天能感應的）

4. 自動延時

開關在接通后，如有人在開關感應范圍內活動則一直接通。若人離開感應范圍則按最后離開前的時間為基準點，開始延時，（延時時間見技術參數）為準，本開關不可調時調光。延時時間為本開關通過調電阻設定的時間為準.一般為20秒-40秒左右)

技術參數：

產品型號:AD01-R1

產品規格：75X38X28MM

工作電壓:AC180V-240V(50/60HZ)

輸出方式：繼電器

負載功率:200W

感應距離：3-5米

感應角度：120度

啟動亮度L：L＜5Lux（相當于晴天天剛亮?xí)r的天空亮度）、

延時時間：20-40秒

適用光源：白熾燈，節能燈，LED燈，日光燈，環形燈管等各種燈具。

使用說明：

1. 請按外殼上的接線圖按裝好開關,通電后一分鐘為初始化時間,在初始化時間內開關通斷為不定態,會連續閃三下,一分鐘后進入正常工作狀態,如白天檢查開關是否正常,可用手蓋住或用黑色物檔住開關,使光線變暗,即可導通燈亮.

2. 延時及感光度為出廠時設定延時的時間和光度為準(具體見技術參數)本開關不可調節延時時間和光度.

3. 安裝本開關時,請不要將開關裝在強光直射及冷熱氣流進出口的位置,不宜裝在噪聲太大的環境下使用.否則會因誤報信號而燈亮,不能達到節能效果.

4. 本開關允許并聯接入,但必須要注意功率問題,不可大于產品規定的負載.本開關對所標負載功率均測試正常,低于所標負載功率可延長開關的使用壽命.

注意事項：

1. 安裝時請斷開電源,確保安全.

2. 禁止超過功率范圍的適用.

3. 不能安裝在水淋到的位置.

4. 探測距離隨環境溫度的變化而變化。夏季探測距離比較短，（與人體溫度接近時最為明顯），冬季探測距離比較遠。

5. 不能安裝在低于-20度和高于60度的位置。

6. 請不要安狀在太陽直射的位置。

7. 建議不要安裝在有活動物體的位置。

售后服務:

凡在本公司購買的產品均可保修18個月.若本產品在購買后的1個月內性能出現問題,且無外觀損壞,劃花,可直接更換新的產品.

下列情況下不屬于保修范圍:

1. 未按說明書要求安裝,使用,維護,保管導致的產品故障或損壞.

2. 己經超出保修期限的.

3. 意外因素或?yàn)槿诵袨閷?dǎo)致產品損壞,如輸入不適合電壓,負載超出規定功率.高溫,進水,摔壞,不按接線圖上指示按裝而燒壞產品等.

本產品己經廣東省中山市古鎮艾迪燈飾電器廠檢驗合格.請放心購買使用!

                制造商：廣東中山市古鎮艾迪燈飾電器廠

                售后保修電話:13421466186

                客服電話：15800142081

                質量監督電話:13715566621

                地址:廣東省中山市古鎮海洲螺沙工業區一號

A human body induction switch.

Product introduction:

Automatic control, based on infrared technology has the advantages of high sensitivity, high reliability, intelligent, humanization,

The switch unipolar design, can be directly replace remote control switch, manual switch, control switch,

Touch switch. No need to change the original wiring, easy to use, can meet all kinds of lamps and lanterns, exhaust fan and other negative

Load.

Scope of application:

This switch can load the incandescent lamp (bulb) and LED light annular lamp, fluorescent lamps and other light source, widely used in hotels, hotel, office,: factory warehouse, residential area, garage, corridor, corridors, entrance, bathroom, elevators and other public places, auxiliary lamps use. Is the best choice of the lighting switch.

Function characteristics:

1 automatic induction

People to light, after a certain period of time delay, people from the lights out. Energy saving and environmental protection.

2 automatic metering

3 application of photosensitive control, daytime or glare not induction, night or can be induced under weak light. (can also be used throughout the day can induction)

4 automatic delay

Switch connected in, if people in the switch in the induction range has been switched on. If people leave the sensing range according to the final before leaving time as a reference point, start delay (delay time, technical parameters.) as the standard, the switch can not be adjusted according to the light. The delay time for the switch through the adjustable resistor to set the time is. For 20 seconds -40 seconds)

Technical parameters:

Product type: HY01-01

Product specifications: 75X38X28MM

Working voltage: AC180V-240V (50/60HZ)

Output mode: relay

The load power: 200W

The induction distance: 3-5 m

Induction angle: 120 degrees

Start the brightness of L:L < 5Lux (equivalent to the sunny day at dawn in the sky brightness),

Delay time: 20-40 seconds

Application: incandescent lamp, energy saving lamp, LED lamp, fluorescent lamp, circular lamp tube, lamp.

Instructions for use:

1 please according to the wiring diagram on the housing install the switch, after electrify a minute for initialization time, the on-off switch for unsteady at initialization time, continuous flash three, enter the normal working state after a minute, as day to check whether the switch is normal, usable hand cover or black fabric up switch, so that the dark, can guide light.

The 2 delay and the sensitivity to the factory set delay time and photometric prevail (see specific technical parameters) this switch can not adjust the time delay and luminosity.

3 the installation of the switch, please do not switch is arranged on the direct sunlight and cold and hot air import and export position, should not be used on too much noise environment. Otherwise they will be false alarm signal lights, can not achieve the effect of saving energy.

4 this switch allows parallel access, but must pay attention to power, load cannot be greater than the product requirements. This switch to standard load power of both tests are normal, below the standard can extend the service life of the switch power.

Matters needing attention:

1 when installed, please disconnect the power supply, to ensure safety.

The 2 forbidden to apply more than power range.

3 can not be installed in the water to the position.

4 detection distance along with the change of environmental temperature changes. Summer detection distance is short, (close to the body temperature was the most significant in winter), detection distance is far away.

5 can not be installed in the lower -20 and higher than 60 degrees position.

6 please don't ANN in the sun position.

7 installation is not recommended in the active object position.

After-sale service.

Where to buy the company's products can be guaranteed for 18 months. If the product in 1 months after the purchase of the performance problems, and the appearance of damage, scratching, can be directly replaced with new products.

The following case does not belong to the scope of warranty:

1 not according to the specifications for installation, use, maintenance, custody of product failure or damage.

2 has been beyond the warranty period.

The 3 accident factors or human behavior damage to the product, if the input is not suitable for voltage, load exceeds the prescribed power at high temperature, water, broken, not according to the wiring diagram indicates the installation and burnt products.

This product has been the ancient town of Zhongshan City, Guangdong Province, Addie Lighting & Electric Appliance Factory Inspection. Please rest assured that the use of purchase!

Manufacturer: Guangdong Zhongshan Addie Lighting Electrical Appliance Factory

Telephone customer service warranty: 13421466186

Customer service telephone: 15800142081

Quality supervision of telephone: 13715566621

Address: Zhongshan City Guangdong Province Haizhou Guzhen Town Luo sand Industrial Zone No.

.